"PanHandler" Rack Extension Now in Beta
Hi oddacorn,
I'm terribly sorry that you didn't get a response. It's not an excuse, but I was "homeless", as in, sold my house and renovating the new one (still is), I have more or less been offline for 3 months after work.
I can setup a forum for you if you still want to?
I'm terribly sorry that you didn't get a response. It's not an excuse, but I was "homeless", as in, sold my house and renovating the new one (still is), I have more or less been offline for 3 months after work.
I can setup a forum for you if you still want to?
Kenni Andruszkow
SoundCloud
SoundCloud
Kenni,
That sounds like a really good excuse to me. I dread the next time I have to move, especially considering all the music gear I've acquired in the last 5 or 6 years!
It would be great if you could still set up a forum for me. I'm in the home stretch of this project, but it will definitely be easier to communicate with my testers if I can send one message to the whole group instead of a few at a time via PM as new folks join.
Thanks, and good luck with your renovations.
Regards,
Todd
That sounds like a really good excuse to me. I dread the next time I have to move, especially considering all the music gear I've acquired in the last 5 or 6 years!
It would be great if you could still set up a forum for me. I'm in the home stretch of this project, but it will definitely be easier to communicate with my testers if I can send one message to the whole group instead of a few at a time via PM as new folks join.
Thanks, and good luck with your renovations.
Regards,
Todd
Thank you for understanding!
I will set it up tomorrow morning (currently 1.15 am here) and write you a PM when it's ready.
I will set it up tomorrow morning (currently 1.15 am here) and write you a PM when it's ready.
oddacorn wrote: ↑08 Nov 2017Kenni,
That sounds like a really good excuse to me. I dread the next time I have to move, especially considering all the music gear I've acquired in the last 5 or 6 years!
It would be great if you could still set up a forum for me. I'm in the home stretch of this project, but it will definitely be easier to communicate with my testers if I can send one message to the whole group instead of a few at a time via PM as new folks join.
Thanks, and good luck with your renovations.
Regards,
Todd
Kenni Andruszkow
SoundCloud
SoundCloud
The latest beta release is now available. All those who have already signed up for the beta test have been issued a license.
Also, thanks to Kenni, The Instrument Panel now has a private forum for beta test discussions. Current beta testers have also been granted access to this forum.
If you are interested in signing up for the beta, there's still time. You can request access to the "The Instrument Panel Beta Tester" forum or send me a PM to get involved.
Enjoy Cyber Monday!
Regards,
Todd
The Instrument Panel
Also, thanks to Kenni, The Instrument Panel now has a private forum for beta test discussions. Current beta testers have also been granted access to this forum.
If you are interested in signing up for the beta, there's still time. You can request access to the "The Instrument Panel Beta Tester" forum or send me a PM to get involved.
Enjoy Cyber Monday!
Regards,
Todd
The Instrument Panel
Latest beta has timed out. Any word on where this is in development?
Here's a status update:
I have issued a new beta release that fixes a problem with several parameters. I don't know if anyone else noticed, but with the previous releases I found that moving the delay feedback, delay mix, wet/dry mix, output width, or volume knobs very quickly back and forth either by hand or via a CV signal with a fairly pure (e.g. sine wave) input audio signal would lead to some clicking that sounded like a dirty potentiometer that needed to be sprayed with contact cleaner. This should no longer be the case.
The new version also automatically forwards the Gate In CV signal to the Gate Out CV jack if that's the triggering source you're using. It also zeros a couple of other CV outputs when entering bypass or off mode that were previously holding their current values. In addition I've added notes in the tooltip descriptions for any CV ins and outs that are not bipolar (most of them are).
My next step will be to release some demo/walkthrough videos. I was hoping to work on this during the holiday break, but my father is in the hospital out of town and I haven't been at home for the last week. I'm going to work on the script until I get back, which should be before New Year's.
I have issued everyone a license for the latest release, so you should be able to download it from the Propellerhead site. If you come up with any cool patches, please feel free to PM them to me or post them in the private beta forum - demo tracks, too!
Regards,
Todd
I have issued a new beta release that fixes a problem with several parameters. I don't know if anyone else noticed, but with the previous releases I found that moving the delay feedback, delay mix, wet/dry mix, output width, or volume knobs very quickly back and forth either by hand or via a CV signal with a fairly pure (e.g. sine wave) input audio signal would lead to some clicking that sounded like a dirty potentiometer that needed to be sprayed with contact cleaner. This should no longer be the case.
The new version also automatically forwards the Gate In CV signal to the Gate Out CV jack if that's the triggering source you're using. It also zeros a couple of other CV outputs when entering bypass or off mode that were previously holding their current values. In addition I've added notes in the tooltip descriptions for any CV ins and outs that are not bipolar (most of them are).
My next step will be to release some demo/walkthrough videos. I was hoping to work on this during the holiday break, but my father is in the hospital out of town and I haven't been at home for the last week. I'm going to work on the script until I get back, which should be before New Year's.
I have issued everyone a license for the latest release, so you should be able to download it from the Propellerhead site. If you come up with any cool patches, please feel free to PM them to me or post them in the private beta forum - demo tracks, too!
Regards,
Todd
I recheck my submitted patches and attach them here today if they require some adjustments due to your changes. Maybe i make some more...oddacorn wrote: ↑28 Dec 2017Here's a status update:
I have issued a new beta release that fixes a problem with several parameters. I don't know if anyone else noticed, but with the previous releases I found that moving the delay feedback, delay mix, wet/dry mix, output width, or volume knobs very quickly back and forth either by hand or via a CV signal with a fairly pure (e.g. sine wave) input audio signal would lead to some clicking that sounded like a dirty potentiometer that needed to be sprayed with contact cleaner. This should no longer be the case.
The new version also automatically forwards the Gate In CV signal to the Gate Out CV jack if that's the triggering source you're using. It also zeros a couple of other CV outputs when entering bypass or off mode that were previously holding their current values. In addition I've added notes in the tooltip descriptions for any CV ins and outs that are not bipolar (most of them are).
My next step will be to release some demo/walkthrough videos. I was hoping to work on this during the holiday break, but my father is in the hospital out of town and I haven't been at home for the last week. I'm going to work on the script until I get back, which should be before New Year's.
I have issued everyone a license for the latest release, so you should be able to download it from the Propellerhead site. If you come up with any cool patches, please feel free to PM them to me or post them in the private beta forum - demo tracks, too!
Regards,
Todd
Best wishes to your father.
Reason12, Win10
Hi, is the work in progress?
My question
It will be possible, if I press a Midi button the sound in the panorama jump hard left and hard right and will be give an amount for the panorama width.
Hope you understand what I mean my English is not the best.
Basically like NNXT / NN19 the Jump function.
My question
It will be possible, if I press a Midi button the sound in the panorama jump hard left and hard right and will be give an amount for the panorama width.
Hope you understand what I mean my English is not the best.
Basically like NNXT / NN19 the Jump function.
please count me in as well
https://soundcloud.com/moneykube-qube/s ... d-playlist
Proud Member Of The Awesome League Of Perpetuals
Proud Member Of The Awesome League Of Perpetuals
This looks like great fun... not seeing it in the shop yet, but the recent videos suggest it might not be long now?
I've started a conversation with Propellerhead Software this week about acceptance testing. Hopefully that will go smoothly and then I'll get this baby pushed out!
- Deep Schulzz
- Posts: 252
- Joined: 23 Jan 2015
Are there any use about this thing?
Edit: Are there any news about this thing?
Edit: Are there any news about this thing?
Last edited by Deep Schulzz on 09 Nov 2018, edited 1 time in total.
Use or news?
Reason12, Win10
-
- Information
-
Who is online
Users browsing this forum: No registered users and 21 guests