Gate to Trigger converter RE?
I swear I had something like this before, but maybe not? I'm looking for an RE that will accept a gate input and output a trigger. I'm doing something where the note on AND the off from the gate are both triggering something I have in the real world, and I would like to just have the trigger, with no gate off. Is there or was there anything in the RS shop like this?
- Stygian Abyss
- Posts: 110
- Joined: 17 Jun 2019
I think you could build that easily with Truth from The Chronologists. Use the rising test with your gate signal as an input, and the output will be a trigger.DJMaytag wrote: ↑09 Feb 2022I swear I had something like this before, but maybe not? I'm looking for an RE that will accept a gate input and output a trigger. I'm doing something where the note on AND the off from the gate are both triggering something I have in the real world, and I would like to just have the trigger, with no gate off. Is there or was there anything in the RS shop like this?
You might be thinking of this device here: https://www.reasonstudios.com/shop/rack ... n/trigate/
But this is doing the opposite of what you want by turning trigger CV into note + gate CV.
But this is doing the opposite of what you want by turning trigger CV into note + gate CV.
- huggermugger
- Posts: 1495
- Joined: 16 Jul 2021
Depending on the response of the device you want to trigger, you may still have the problem even with a trigger. A trigger is simply a gate with a very short gate time. It necessarily has to go 'low' after it has gone 'high' - if not, it can't go 'high' again.
- Stygian Abyss
- Posts: 110
- Joined: 17 Jun 2019
Exactly, that's why I suggested the rising test of Truth: it goes 'low' as soon as the input CV stops increasing. I've just tested it in the RRP while visualizing the output with Pongasoft's excellent CVA-7 device, the result is what the OP wants.huggermugger wrote: ↑09 Feb 2022Depending on the response of the device you want to trigger, you may still have the problem even with a trigger. A trigger is simply a gate with a very short gate time. It necessarily has to go 'low' after it has gone 'high' - if not, it can't go 'high' again.
Nice. I will give that a shot!
- Stygian Abyss
- Posts: 110
- Joined: 17 Jun 2019
You may also be interested by a trigger happening when a key is released. Do the same rising logic test in Truth using a second slot, but use the Inv output of a Spider CV Splitter instead of a direct copy of your gate signal.
You can also use Europa for this, really easy to set up too!
- Set envelopes 1 and 2 to square waves.
- Invert 1 if them
- Enable sustain on both
- Use cv outputs
- Done
12 +
Patch Randomizer: topic - https://mjxl.net/remoter/
Complex-1 Community Refill: topic - https://mjxl.net/rsn/Complex-1%20Community%20ReFill.rfl
Patch Randomizer: topic - https://mjxl.net/remoter/
Complex-1 Community Refill: topic - https://mjxl.net/rsn/Complex-1%20Community%20ReFill.rfl
How about this free RE?
https://www.reasonstudios.com/shop/rack ... ic-driver/
https://www.reasonstudios.com/shop/rack ... ic-driver/
The gate out of Redrum isn’t working like that. It’s still a gate out.
-
- Information
-
Who is online
Users browsing this forum: No registered users and 20 guests