Glad I waited. Research time.
Thanks for the Head's up!
I've read there's a lot going on under the hood for these, though it's also using the cheap pt2399 chip.
I don't want to say that the pt2399 is a bad chip at all, it's just you can get them for about $1.50. It's the circuit you build around it.O1B wrote: ↑15 Jan 2020Thanks for the chip heads up... ill keep an eye out for confirmation.
Im good with my Delay choices... a couple more to try... Z-DSP... Rainmaker...
But, I really need a nice Reverb mod.
Catblack wrote: ↑15 Jan 2020...
I'm probably going to use one or two for timing in a mod of a cheap chinese reverb module I'm working on. If it all turns out ok I'll maybe have a pcb/panel set designed this spring. I've got to get the units, breadboard, then stripboard and then design a pcb.
I should do a thread here with my builds so far...
Check out the specs on https://www.vult-dsp.com/freak
Looks really great.
Moogfest 2019 was cool, and so was building a $1500 "free" module, the Spectravox. Sadly, there's no Moogfest 2020, and I had to sell my Spectravox to fund some other things I needed to take care of in there studio.
Noise Engineering just dropped a new dedicated reverb module at NAMM this week, Desmodus Versio
DJMaytag wrote: ↑16 Jan 2020Noise Engineering just dropped a new dedicated reverb module at NAMM this week, Desmodus Versio
Qu-Bit Aurora also was announced at NAMM, and if it's as good as Bloom, Prism, & Chord (I bought all three recently), then Aurora should be amazing.
https://www.gearnews.com/namm-2020-qu-b ... e-modules/
DJMaytag wrote: ↑13 Apr 2020That’s dope. Indeed the firmware can be swapped for use as a Bitbox or Synthbox, but not Toolbox. Anyway, I’ve paid more attention to using it as Bitbox, but FXBox looks awfully intriguing. I wasn’t aware the FX could be sequenced like that. I assume the inputs allow the various FX to be triggered externally?
Paul’s stuff is amazing and unique. I heard an early prototype of this thing at Knobcon last September. He’s done SO much updating and adding to it since then, so you’re gonna get an amazing machine!
Users browsing this forum: No registered users and 1 guest