hi
I'm new. but anyway. I can't seem to figure out how to route my vst drum sample( Steven Slate drums ) into redrum so I can use those drums sounds and sequence them. I know how to route kong into redrum which is pretty straight forward but for some reason nothing happens when I try to route the vst into redrum. Basically I don't understand the routing process. I tried for like two hours putting every wire into every plug possible but I hit a wall, so I'm reaching out for help.
Thanks
how to sequence a vst drum sample with redrum ??
Doesn’t the free Panda CVPT allow for that too?ebbhead wrote: ↑21 May 2020Easiest way to do this is to get hold of Robotic Bean's TM1 Trigger Multiplexer RE - this will allow you to use devices with individual trigger CVs (like Redrum) to sequence other devices that only have single CV/Gate inputs - like NNXT and VSTs.
Screen Shot 2020-05-21 at 09.58.21.png
Also Retouch Control Tone Rows.
🗲 2ॐ ᛉ
hello,
can't the op locate the folder where the actual samples are
then load those into redrum and proceed to sequence?
perhaps, even drag and drop (not sure)
i'm not familiar with stevenslatedrums
have a goodgood day,
j
can't the op locate the folder where the actual samples are
then load those into redrum and proceed to sequence?
perhaps, even drag and drop (not sure)
i'm not familiar with stevenslatedrums
have a goodgood day,
j
littlejamaicastudios
i7 2.8ghz / 24GB ddr3 / Quadro 4000 x 2 / ProFire 610
reason 10 / reaper / acidpro /akai mpk mini / korg padkontrol / axiom 25 / radium 49
'i get by with a lot of help from my friends'
i7 2.8ghz / 24GB ddr3 / Quadro 4000 x 2 / ProFire 610
reason 10 / reaper / acidpro /akai mpk mini / korg padkontrol / axiom 25 / radium 49
'i get by with a lot of help from my friends'
-
- Information
-
Who is online
Users browsing this forum: No registered users and 11 guests