Automation clips issue / bug?
The automation lanes make CHANGES to the default setting. Click on the automation lane, and then check the default setting in the column that says 'Drum1 FX1 P1' in your snapshot image. You can click on the dot and change it's value. I hope that helps!
visit http://www.napynap.com to learn more about me. Thank you.
-
- Posts: 3732
- Joined: 20 Oct 2017
- Location: Norway
- Contact:
I've dealt with this for several years. Doesn't happen with every device, I think, but filters are usually the ones that have this behaviour. shortening or drawing a sweep back to original position right before the next bar is what I do to get around it.
- Boombastix
- Competition Winner
- Posts: 1929
- Joined: 18 May 2018
- Location: Bay Area, CA
I don't know, but it can be a "feature", ie it has a lag built in to avoid digital zipper noise. Though it would arguably be better if it also had a look ahead feature, which it appears it doesn't have. My guess is it's just how it is coded, not a bug per se, but could be improved upon.
Sent from my Moto G (5) Plus using Tapatalk
Sent from my Moto G (5) Plus using Tapatalk
10% off at Waves with link: https://www.waves.com/r/6gh2b0
Disclaimer - I get 10% as well.
Disclaimer - I get 10% as well.
-
- Information
-
Who is online
Users browsing this forum: No registered users and 24 guests