Page 1 of 1

VST vs RE timing

Posted: 31 Jan 2021
by XSynth
By accident i noticed REDRUM kicks lag behind a VST triggered by Korde.

Ex. I run a clicky kick in REDRUM 4 on 4
Then i use Korde to trigger a 4 on 4 clicky sound in Zebra VST.

For some odd reason the Clicky sound from Zebra is wayyy ahead of the clicky sound from REDRUM.

Ahha i thought this must just be a bad optimized kick playing in the REDRUM, so i try other clicky kicks and to my horror its the same thing happening.

If something should lag a little behind then i would have thought it would be the VST but no, its the Redrum.

I could even hear it with a VST bass playing to the REDRUM Kick.

Anyone got a clue whats going on ?

Re: VST vs RE timing

Posted: 31 Jan 2021
by PhillipOrdonez
Strange. Perhaps there's an issue with the delay compensation?

Re: VST vs RE timing

Posted: 31 Jan 2021
by antic604
XSynth wrote:
31 Jan 2021
By accident i noticed REDRUM kicks lag behind a VST triggered by Korde.
Are you by any chance doing any non-standard routing with Redrum?

Re: VST vs RE timing

Posted: 31 Jan 2021
by XSynth
Both the Redrum and korde with the Zebra VST is inside a Combinator. I'm using no weirdo routings or anything.

Re: VST vs RE timing

Posted: 31 Jan 2021
by Billy+
What setting / samples are you using?

Re: VST vs RE timing

Posted: 31 Jan 2021
by miscend
Is PDC enabled? Also Redrum has knobs for adjusting start and there r different gate trigger modes. Make sure they are set correctly.

Re: VST vs RE timing

Posted: 31 Jan 2021
by XSynth
My fault.... i'm soooo sorry. I must be VERY tired, this behavior happend because i was NOT running the transport. Things are syncing OK again. Damnnnn gonna need more coffee.

Re: VST vs RE timing

Posted: 31 Jan 2021
by Billy+
XSynth wrote:
31 Jan 2021
My fault.... i'm soooo sorry. I must be VERY tired, this behavior happend because i was NOT running the transport. Things are syncing OK again. Damnnnn gonna need more coffee.
Try less coffee