Hi All, when I put the Kilohertz Tape Stop RE on the master bus and automate the Bypass/On switch, there's a noticeable pop when it switches from "bypass" to "on" and vice versa. Anybody know a way around this? Is it a latency thing?
Thank you!
Kilohertz Tape Stop "pop" sound
A lot of devices pop when turning them on. Just the hard edge from dry to wet signal is enough to cause it. If I use the bypass switch, I make sure it's changed during a silent passage.
Try a cross-fade instead. There are a couple x-fade REs in the shop, and I believe some patches in the factory sound bank that can do it too.
OK Thank you. I'd leave it on but I think it does affect the signal when "On", to my ears at least.ScuzzyEye wrote: ↑09 Apr 2019A lot of devices pop when turning them on. Just the hard edge from dry to wet signal is enough to cause it. If I use the bypass switch, I make sure it's changed during a silent passage.
Try a cross-fade instead. There are a couple x-fade REs in the shop, and I believe some patches in the factory sound bank that can do it too.
-
- Information
-
Who is online
Users browsing this forum: Google [Bot] and 8 guests