Carve issues after rendering?!

This forum is for discussing Rack Extensions. Devs are all welcome to show off their goods.
User avatar
VNUprod
Posts: 93
Joined: 04 Mar 2015

Post 14 Mar 2015

Hey folks,

Iwas just trying out the carve with a current mixing mission. It could have been just an accident, I don't know, but listening to the exported audio file, there were crackling noises several time and only in the parts where carve was used. then I  deactivated it, same result. Then I deleted all carves and the mixdown was just fine. I used the parallel outs to feed the carves reference in btw.

Anyone experienced somethin similar (maybe it really was just an accident though...)?

User avatar
Shokstar
Posts: 371
Joined: 15 Jan 2015

Post 14 Mar 2015

could you reproduce it in a new session? for example with 1-2 instruments?

User avatar
VNUprod
Posts: 93
Joined: 04 Mar 2015

Post 15 Mar 2015

Hey, I found a minute to check this and set up a two track session rebuilding the same setup as in the mix project. and it worked flawlessly! :roll:

So I guess the problem ocurred, because the mix project was already driving my hardware towards its limits... .

  • Information
  • Who is online

    Users browsing this forum: CommonCrawl [Bot] and 2 guests