Page 1 of 1
Pre Master and Post Master Channels
Posted: 23 Jun 2019
by PrivatePartsUK
Hey Fellow Reasoners,
Does anyone know how to set up a Pre Master and Post Master Channels in Reason 10 please?
Thanks in advance.
ppuk
Re: Pre Master and Post Master Channels
Posted: 23 Jun 2019
by jam-s
pre master: simply bus everything into a new bus. That bus is your pre-master channel.
post master: in the Rack put all the FX you want between mixer "master out" and "Audio I/O" section of the hardware interface.
Re: Pre Master and Post Master Channels
Posted: 21 Jan 2020
by Jowe79
But when you tells “in the Rack put all the FX you want between mixer "master out" and "Audio I/O" section of the hardware interface” what means? All effects as inserts inside insert slot of master section? Please a little bit confused.....
Re: Pre Master and Post Master Channels
Posted: 21 Jan 2020
by selig
Jowe79 wrote: ↑21 Jan 2020
But when you tells “in the Rack put all the FX you want between mixer "master out" and "Audio I/O" section of the hardware interface” what means? All effects as inserts inside insert slot of master section? Please a little bit confused.....
You've asked this before, and it's been answered before, remember?
viewtopic.php?t=7515791
Here's a picture showing how I did it (from the thread linked above):