Hi There,
I'm pretty convinced this should be possible but... how?
I have Reason 8 installed and when i'm finishing a track i always use a reference track (Madonna's Frozen) to compare overal sound, levels, etc.
But how do i set this within Reason or how do you guy's do this?
I can place this reference wav on a Audio track and solo it, but then it also uses the Master Insert's and Master Compressor.
Although i can also disable these with a few click's, i want to use a 1 click system so i can switch during the playback of the system.
The Madonna track should be routed to a separate out but the back of the IO-panel won't allow me to do this because red led blink up if i try to do so.
I'm using a Focusrite Saffire Pro 24.
Any tips?
Bypass/Solo a reference Track in Reason
Flower Loudness meter gives this option
https://shop.propellerheads.se/browse/? ... ness+Meter
https://shop.propellerheads.se/browse/? ... ness+Meter
- dandandaaan
- Posts: 62
- Joined: 01 Mar 2016
- Location: London, UK
- Contact:
I may be wrong, but couldn't you also use the control room output??
singer/songwriter with electronic tendencies
http://pointsmusic.bandcamp.com/
https://soundcloud.com/points_music
Logic / Ableton Live / Reason Rack / Nord Stage 2 / Moog Grandmother / Eurorack / Guitars, drums, toys
http://pointsmusic.bandcamp.com/
https://soundcloud.com/points_music
Logic / Ableton Live / Reason Rack / Nord Stage 2 / Moog Grandmother / Eurorack / Guitars, drums, toys
Sure. Reserve FX channel 8, send audio track to it, mute its return, then switch control room source between Master and FX send 8.dandandaaan wrote:I may be wrong, but couldn't you also use the control room output??
-
- Information
-
Who is online
Users browsing this forum: No registered users and 15 guests