Europa Remote
I don’t know if it’s the right place to ask but can somebody confirm that there is a wrong behavior when using a button to remote control (via à remote map file) the wave selector of any of Europa oscillators ? Using a knob or rotary is ok but not with a button which should step thru all the values
From my experience with remotes, pressing a button normally behaves like a on/off, and not incrementally. Like the on state should trigger only the last item in the list, in this case, the last wave table.
Albums: BandCamp | Youtubz: Noise Channel
Projects: P1 Easy Remote Mapping | Personal Refill Sale Store: https://payhip.com/noisesystems | Title Generator! untitled.noiseshadow.com
Projects: P1 Easy Remote Mapping | Personal Refill Sale Store: https://payhip.com/noisesystems | Title Generator! untitled.noiseshadow.com
It is not a bug and both behaviors exist. From memory: try filter selection on subtraktor, or dynamic on redrum - one button steps through all steps. But it all depends on how the buttons are set up in the codec and on the midi device itself and of course how it is set up in the software device.
Generally a button on a controller switches between 0 and 127 values, min max, on off.
If you assign a button to any list, it will toggle between the first and last element of that list.
If you assign it to a slider it will toggle between min and Max values
If you assign a button to any list, it will toggle between the first and last element of that list.
If you assign it to a slider it will toggle between min and Max values
-
- Information
-
Who is online
Users browsing this forum: No registered users and 32 guests