Can you select multiple outputs on one channel?

This forum is for discussing Reason. Questions, answers, ideas, and opinions... all apply.
Post Reply
ToddPatterson
Posts: 5
Joined: 11 Jun 2018

20 Jul 2018

OK here's what I'm trying to do...
I want to send the entire mix to two different busses, one dry and one with plugs on it.
Then have those two busses going to my master fader
I can only imagine it being accomplished by sending each of my instrument busses to two outputs.
Can this be done?

User avatar
Loque
Moderator
Posts: 11175
Joined: 28 Dec 2015

20 Jul 2018

You can always split a audio signal with a Audio Spider and send it somewhere else. Grab it from the parallel out or insert To Devicd.

In your case parallel bussing the fx could be enough, if done clever. Also note, that you can always route your send fx to a dedicated mix channel, which gives you control over the volume, allows further routing and processing.
Reason12, Win10

ToddPatterson
Posts: 5
Joined: 11 Jun 2018

20 Jul 2018

Thanks Loque!
I totally forgot about the Spider.
Worked like a charm!

Thanks again

Todd

Post Reply
  • Information