OK here's what I'm trying to do...
I want to send the entire mix to two different busses, one dry and one with plugs on it.
Then have those two busses going to my master fader
I can only imagine it being accomplished by sending each of my instrument busses to two outputs.
Can this be done?
Can you select multiple outputs on one channel?
You can always split a audio signal with a Audio Spider and send it somewhere else. Grab it from the parallel out or insert To Devicd.
In your case parallel bussing the fx could be enough, if done clever. Also note, that you can always route your send fx to a dedicated mix channel, which gives you control over the volume, allows further routing and processing.
In your case parallel bussing the fx could be enough, if done clever. Also note, that you can always route your send fx to a dedicated mix channel, which gives you control over the volume, allows further routing and processing.
Reason12, Win10
-
- Posts: 5
- Joined: 11 Jun 2018
Thanks Loque!
I totally forgot about the Spider.
Worked like a charm!
Thanks again
Todd
I totally forgot about the Spider.
Worked like a charm!
Thanks again
Todd
-
- Information
-
Who is online
Users browsing this forum: No registered users and 25 guests