Your "Go To FX" Sends/Returns for mixing
I do have my 8 sends set up on my template file as I found I used certain reverbs a lot with much the same settings each time. I have two uhbik-A's one room and one hall but don't use the much any more. I have tsar-1 with a studio setting and some high end taken off which I use a lot and a dr-1 with bottom taken off that I use a. Lot too. There's an echobode in there and the others get changed around a bit.
I do parallel compression on sends.
my setup is basically :
1 RV7000 ( Long reverb )
2 RV7000 (Short reverb )
3 The Echo ( 1/8 Delay )
4 The Echo ( 1/4 Delay , 1/2 Delay etc )
5 DDL-1 Haas effect for widening
6 FRG Compressor for Parallel processing
This is my template to get me started but it may change if the current project needs something different .
1 RV7000 ( Long reverb )
2 RV7000 (Short reverb )
3 The Echo ( 1/8 Delay )
4 The Echo ( 1/4 Delay , 1/2 Delay etc )
5 DDL-1 Haas effect for widening
6 FRG Compressor for Parallel processing
This is my template to get me started but it may change if the current project needs something different .
- submonsterz
- Posts: 989
- Joined: 07 Feb 2015
None all ways a new song with new needs best to start from scratch for me everytime. Had my time of making templates that i ended up wasting time moving,replacing or deleting things in.
I only have a couple of templates and they are rewire set ups for my differentt daws.
I only have a couple of templates and they are rewire set ups for my differentt daws.
-
- Information
-
Who is online
Users browsing this forum: No registered users and 22 guests