2 Mono tracks panned going to Output Bus= Stereo track but no panning?

[normen]

This shouldn't happen, how did you route them to the bus? Using Reason 7 buses?

[buddard]

Did you check the width setting on the bus channel?

[Olivier]

Would you be willing to share the project file ? (a slimmed down version maybe where the error occurs)... There's no way i can reproduce this.

[normen]

I gotta ask again. So you clicked on "Output v" down in one mix channel and selected "New Output Bus" and then selected that same bus the same way in the other channel?

[Gaja]

Sorry for asking this, but are you talking about two different tracks? It's not the same signal twice? Just to be sure