Record Enable Parameter Automation (REPA) button

[Raveshaper]

Before I give up in despair, I'll ask and see if anyone has a silver bullet for this problem.

In the Remotables list from the PH site, the only mapping that can be bound to the REPA button is dependent on the selected sequencer track in standard mode and is dependent on the last selected sequencer track in separated mode.

What I want is to toggle the REPA of several sequencer tracks without having to change the sequencer track selection, as this would most likely cause more problems than it would fix.

Is this in any way possible? Maybe by using fixed values instead of delta?